Bosch Glide Miter Saw Problems With Best Solution

After a use time, your old Bosch Glide Miter Saw begins having some problems that make you hard to complete your woodwork? However, you do not want to use the customer service because of its huge cost, instead of you decide to solve the issue by yourself.

No problem! We will help you by offering the best solutions for the problems of your Bosch Glide Miter Saw.

Roll down!

Bosch Glide Miter Saw Problems With Best Solution

Problems of Your Bosch Glide Miter Saw

Throughout using the Bosch Glide Miter Saw, you might meet a couple of frustrating problems. In particular, here are:

Incapable Dust Collection

Sawdust going via the provided hose will gradually stick all over the back of the saw. Even in case, a machine has a dust bag to plug into the 90-degree hose, it is not enough to make you satisfied. The simple reason is due to its bend, making the airflow as well as suction power reduce.

For fixing the dust collection problem,  it would be best to connect the miter saw with your worksite table saw. As a useful reference source, you can access https://www.discoveriesla.com/bosch-4100-09-review to look up more information.

Tear-out problems

There is probably a clearance between the blade and the insert edges (you likely get the knowledge related to this at Home Improvement Blog). Hence, your work becomes less supportive, and the board bottom can appear in the tear-out problem. Finally, you cannot perform clean cuts at all

Best Solutions

Let’s feel secure because you can get rid of the hassles of your older Bosch Glide Miter Saw by following upgrades below:

Modify your Dust Collection

For removing the 90° bend, you start twist-pulling it off and installing the dust hose onto your miter saw’s the plastic dust shroud. Continuously, direct this hose in a place where you want to. Make sure that you will see an awesome difference? It is noticeable that sawdust will not fly all over your woodwork place.

Make a Zero Clearance Insert

A Zero Clearance Insert

Start to measure the throat plate of your miter saw. Next, cut a part of plywood with thickness and length accordingly. You’d better remember to position the screw holes on the zero clearance insert, and drilling them. The last one, build in that insert in the location of the throat plate, making clean cuts on it (from up and down).

In Sum

For the time being, have you probably got helpful tricks to improve the performance of your miter saw? Yes, you might perform cuts in the sharper way without tearing-out while the problems related to sawdust are free.

We hope that your Bosch Glide Miter Saw becomes better after following our solutions.

Do it your way!

You have been using your Bosch Glide Miter Saw for a while but now run into some problems that frustrate you and your woodwork? Instead of calling the customer service and getting ready for the hefty shipping fee to get them fixed, you want to compromise by yourself?

No more worries, here we provide some of the best solutions for problems of your Bosch Glide Miter Saw.