How To Make A Hallway Table: 6 Simple Step?

You can easily make a hallway table at home.

A lovely hallway table will not only adorn the beauty of your house but also become a convenient place for storing your belongings. So, how to make a hallway table: 6 simple steps?

There are many ways to make your hallway table stand out. But as a beginner, you might think that the building process is way too complicated.

Let’s set aside the troublesome process, this writing will give you the most simple solution for building a table saw for beginners in just a six-step procedure!

How To Make A Hallway Table: 6 Simple Step.

Step 1: Prepare the Materials

You will need:

  •         Four poplar end rails
  •         Two oak stiles
  •         Four poplar legs
  •         Two side rails of poplar
  •         One middle rail of poplar
  •         One stretcher from oak
  •         Three top slats oak

You can have a saw table for beginner

Step 2:  Build Up The Side Pieces

On the two ends of stiles, you drill two pocket holes. Stain the above stiles and leave them there to dry. On the end rails, you stick stiles at the center. Next, you add glue and insert the plugs into the pocket holes.

Now you can start painting the legs of the table. When they are dry, you insert the legs into the stile assemblies’ end. If you aren’t a DIY person, it’d better have a look at https://www.discoveriesla.com/best-portable-table-saw-for-fine-woodworking to find a table saw for beginners.

Step 3: Build The Base & Connect The Sides

On the two ends of the stretcher, you drill and paint the pocket holes. Then you need to drill the pocket holes perpendicularly to the assemblies tops to keep side rails.

Create the end rails layout and position the middle one with glue at the side rails’ center.

You stick the stretcher at the center and in line with the end edge of the last rails.

Step 4: Form The Top

You position the end grain at the center of the up curve and the down curve. Apply glue on the edges and stick the parts with flush ends and lightly clamp.

On slats and cauls top, you need to tighten the clamps and make adjustments if needed. Next, you can cut the last top assembly following the table’s saw or in a circle.

Lastly, you can apply paint to all parts of the top.

Step 5: Arrange All Parts Together

For the next step, you put the top part of the table at the center of the assembly base and use 1/4-inch pocket hole screws as a connection.

Step 6: Carry Out The Finishing Steps

In the pocket holes, you apply some glue and insert paintable plugs. Finally, to have a wonderful hallway table, you should clean the excess glue and paint it if necessary.

Sum up

With all the detailed instructions above, you might now have an overview of how to make a hallway table: 6 simple steps, haven’t you?

It is not hard to follow. You only need to prepare things fully and practice steps carefully. Hope you have the best hallway table ever! Cheer!